Makita RP1800 Instruction Manual

Also see for RP1800: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

Makita RP1800 Instruction Manual Manual pdf 12 page image

1210099332. Adjusting the depth of cut• A small amount of depth of cut can be obtained byturning this screw with a screwdriver from abovethe table. (1.0 mm per a full turn)• Turning it clockwise makes the depth of cut greaterand turning it counterclockwise smaller.1009931MAINTENANCECAUTION:• Always be sure that the tool is switched off andunplugged before attempting to perform inspectionor maintenance.Replacing carbon brushes1001145Remove and check the carbon brushes regularly.Replace when they wear down to the limit mark. Keepthe carbon brushes clean and free to slip in the holders.Both carbon brushes should be replaced at the sametime. Use only identical carbon brushes.Use a screwdriver to remove the brush holder caps.Take out the worn carbon brushes, insert the new onesand secure the brush holder caps.12009869After replacing brushes, plug in the tool and break inbrushes by running tool with no load for about 10minutes. Then check the tool while running and electricbrake operation when releasing the switch trigger. Ifelectric brake is not working well, ask your local Makitaservice center for repair.To maintain product SAFETY and RELIABILITY, repairs,any other maintenance or adjustment should beperformed by Makita Authorized Service Centers,always using Makita replacement parts.ACCESSORIESCAUTION:• These accessories or attachments arerecommended for use with your Makita toolspecified in this manual. The use of any otheraccessories or attachments might present a risk ofinjury to persons. Only use accessory orattachment for its stated purpose.If you need any assistance for more details regardingthese accessories, ask your local Makita Service Center.• Straight & groove forming bits• Edge forming bits• Laminate trimming bits• Straight guide• Trimmer guide• Guide holder• Templet guides• Templet guide adapter• Lock nut• Collet cone 12 mm, 1/2"• Collet sleeve 6 mm, 8 mm, 10 mm• Collet sleeve 3/8", 1/4"• Wrench 24• Vacuum head set1. Brush holdercap2. Screwdriver1. Limit mark1. Screwdriver1. Threaded part inthe motorbracket