Makita UM164D Instruction Manual

Also see for UM164D Series: Instruction manual Instruction manual Instruction manual Instruction manual Technical information

Contents

1412 3011044• Chip receiver for hedge trimming (for HedgeTrimmer)Installing or removing hedge shear bladesCAUTION:• Before installing or removing shear blades, alwaysbe sure that the tool is switched off and the batterycartridge is removed.• When replacing the shear blades, always weargloves without removing blade cover so that handsand face do not directly contact the blade. Failureto do so may cause personal injury.NOTE:• Do not wipe off grease from the gear and crank.Failure to do so may cause damage to the tool.• For specific way of removing and installing shearblades refer to the reverse of a package foraccessory shear blades.Installing the hedge shear blades1 23010904Prepare the crank, the undercover and new shearblades.1 2010905Adjust the three pin position so that these three pins arealigned with the basic alignment line on the tool housing.1234010906Fit the crank with its recessed part facing downward ontothe pins. At this time, apply a small amount of grease tothe periphery of the crank using grease that the shearblades as optional accessory are provided with or thatremains inside gear housing.1. Hedge shear blade2. Hedge shear blade cover3. Storage case1. Crank2. Undercover3. Shear blades1. Basic alignment line on the tool housing2. Pins1. Crank2. Apply grease.3. Pins4. Recessed part of crank