Makita WST05 Instruction Manual

Also see for WST05: Instruction manual Instruction manual

54. To stabilize the stand, loosen the round nut (25) andturn the adjusting feet (24). Retighten the round nut(25) after the setting.Folding: (Fig. 4)1. Place your foot on the support (14).2. Slightly pull up the handle (23) with both hands andpull the release lever (26).3. Lower the handle (23) under the height level 1. Thelocking lever (22) locks the handle by itself.Setting the extension arms: (Fig. 5 & 6)1. Turn the lever (27) which has the same functions asthe lever (16) toward the miter saw.2. Pull out the extension arm (28) to your desired length.3. Tighten the lever (27).4. Pull out the pin (29) and pivot the leg. Make sure thatthe pin locks the leg.5. Loosen the clamping screw on the leg, pull out the legpipe (32) until it reaches the floor and retighten theclamping screw (31).6. Loosen the clamping screw (31) for the support, raiseor lower the support until the top edge of the supportreaches the miter saw table height. Retighten theclamping screw (31).7. When using the stopper (34) for repetitive cuts, loosenthe clamping screws (33) and raise the stopper (34).Retighten the clamping screws (33) to secure thestopper (34).Storing the extension arm: (Fig. 5 & 6)Follow the procedure of “Setting the extension arms” inreverse.