3ENGLISH (Original instructions)Explanation of general view1-1. Grip base1-2. Teeth1-3. Side grip (auxiliary handle)1-4. Protrusion1-5. Loosen1-6. Tighten2-1. Drill chuck2-2. Chuck key3-1. Sleeve3-2. Ring4-1. Side grip4-2. Depth gauge4-3. Grip base5-1. Switch trigger5-2. Lock button6-1. Reversing switch lever7-1. Action mode changing leverSPECIFICATIONSModel MT814 MT815Concrete 16 mmWood 30 mmCapacitiesSteel 13 mmNo load speed (min -1) 0 - 3,200Blows per minute 0 - 48,000Overall length 296 mm 295 mmNet weight 2.1 kg 2.0 kgSafety class /II• Due to our continuing program of research and development, the specifications herein are subject to change without notice.• Specifications may differ from country to country.• Weight according to EPTA-Procedure 01/2003ENE039-1Intended useThe tool is intended for impact drilling in brick, concreteand stone as well as for drilling without impact in wood,metal, ceramic and plastic. ENF002-1Power supplyThe tool should be connected only to a power supply ofthe same voltage as indicated on the nameplate, andcan only be operated on single-phase AC supply. Theyare double-insulated in accordance with EuropeanStandard and can, therefore, also be used from socketswithout earth wire. ENG905-1NoiseThe typical A-weighted noise level determinedaccording to EN60745:Sound power level (LWA) : 109 dB (A)Sound pressure level (LpA) : 98 dB (A)Wear ear protectionENG900-1VibrationThe vibration total value (tri-axial vector sum)determined according to EN60745:Work mode: impact drilling into concreteVibration emission (ah,ID) : 16.5 m/s 2Uncertainty (K) : 2.0 m/s 2Work mode: drilling into metalVibration emission (ah,D) : 3.0 m/s 2Uncertainty (K) : 1.5 m/s 2ENG901-1• The declared vibration emission value has beenmeasured in accordance with the standard testmethod and may be used for comparing one toolwith another.• The declared vibration emission value may also beused in a preliminary assessment of exposure.WARNING:• The vibration emission during actual use of thepower tool can differ from the declared emissionvalue depending on the ways in which the tool isused.• Be sure to identify safety measures to protect theoperator that are based on an estimation ofexposure in the actual conditions of use (takingaccount of all parts of the operating cycle such asthe times when the tool is switched off and when itis running idle in addition to the trigger time).ENH101-14For European countries onlyEC Declaration of ConformityWe Makita Corporation as the responsiblemanufacturer declare that the following Makitamachine(s):Designation of Machine:Hammer DrillModel No./ Type: MT814,MT815are of series production andConforms to the following European Directives:2006/42/EC