Manitowoc Chiplet QC0700 Installation, Use & Care Manual

Also see for QC0700: Service manual Building instructions Service manual Technician's handbook

Contents

Ice Machine Sequence of Operation Section 44-2 Part Number 000002688QF2300PRIOR TO START-UPWhen the toggle switch is placed in the “ice” position thefollowing must occur prior to starting an ice makingcycle.A. The bin level probe must be open (bin levellight off). If the probe is closed, (bin level lighton) when the toggle switch is moved to ICE, thecontrol system waits until the bin level probeopens, (bin level light off) before starting an icemaking sequence. If the bin level probe isremoved/disconnected the ice machine will notstart.B. The water level probe must be closed (waterlevel light on) to start the compressor. If thewater level probe is open, (water level light off)the control system waits until the water levelprobe closes before starting the compressor.INITIAL START-UP1A. FlushImmediately after placing the toggle switch into ICE, thedump valve solenoid, and gearbox are energized. After45 seconds the dump valve de-energizes.1B. Water FillAfter 45 seconds the water float valve solenoid isenergized.2. Freeze CycleWhen water contacts the water level probe the liquid linesolenoid valve, equalization valve, compressor andcondenser fan motor energize (condenser fan motor iswired through a fan cycling control).The gear motor, compressor, condenser fan motor andwater float valve solenoid remain energized as the icemachine makes ice. The water float valve will open andclose automatically to maintain the proper water level.AUTOMATIC SHUT-OFF3A. Ice Run OutIce will build up in the bin until it contacts the bin levelprobe. After ice contacts the bin level probe for 30continuous seconds the liquid line solenoid valve,equalization valve and compressor de-energizes.To allow excess ice to run out, the gear motor and thewater float valve solenoid remain energized for anadditional 4 minutes, then de-energize.3B. Water DrainTo allow water to drain from the evaporator, the dumpvalve energizes for 90 seconds, then de-energizes.An 8-minute lockout starts when the compressor de-energizes. When the ice drops away from the bin levelprobe the ice machine will begin an initial start-up cycle,provided the “8-minute lockout” has expired.8 Minute LockoutThe bin level light will flash until the 8-minute lockoutexpires.After the 8 minute lockout expires the bin level light willde-energize.The 8 minute lockout time can be overridden by movingthe ON/OFF/CLEAN toggle switch from ICE to OFF thenback to ICE.FLUSH SEQUENCE IN THE “ICE” POSITIONAfter the ice machine has run for 100 hours the icemachine will stop making ice and perform a flushsequence. The flush sequence will remove minerals thathave settled in the bottom of the evaporator. The entireflush sequence lasts approximately 11 minutes, afterwhich the ice machine automatically resumes icemaking and the 100 hour counter in the control boardresets to zero.NOTE: Flake ice machines use an auger to remove icefrom the evaporator. Occasional noises (creaks, groans,or pops) are a normal part of the ice making process.