48” Q-Model Water/Remote InsulationInstallation InstructionsMaterial List Q-1300/Q-1800 Ice Machines:Quantity1 Armaflex Insulation 6’ x 2” ID x 3/8” wall thickness1 Armaflex Insulation 6’ x 3/4” ID x 3/8” wall(used on evaporator inlet/outlet and dump valve drain line)1 Bulkhead Insulation Back 9” x 48” x 3/4”1 Bulkhead Insulation Back 3” x 48” x 3/8”2 Side Wall Insulation 9” x 10” x 3/8”2 Bulkhead Corner Insulation Cover 6” x 1” x 3/8”1 Bulkhead Insulation (behind dump valve) 3 3/8” x 5 5/8” x 3/8”1 Vacuum Formed Base with Insulation 12 3/4” x 48” x 3/4”1 Foam Gasket For Top Edge of Bin 2’ x 3/4” x 1/4”4 Evaporator Inlet/Outlet Insulation 3” x 3” x 3/8”1 Tube Silicone Sealant Black Used to seal base/bulkhead insulation1 Tube Silicone Sealant White 3 oz Used to seal front edge of vacuum-formed base1 Mylar Strip 5” x 42”1 Double Face TapeAdditional materials required: caulk gun, 2” x 4’ wood blocks, wire ties.Preparation1. Disconnect power from ice machine.2. Remove front, top, and side panels.3. Drain water from sump trough.4. Ice machine must be thoroughly dried before the insulation can be installed. Use towels to dry bulkhead and base assembly.Base Insulation Installation1. Raise the ice machine above the bin. A high lift can be used or (two people required) lift front edge of ice machine and placewood blocks (2”x4”) between ice machine and bin. Lifting one side of ice machine at a time, move wood blocks to centerbalance point of ice machine.2. Slide vacuum formed base insulation assembly between the ice machine and bin. Align the insulation with the back and sides ofthe bin and ice machine.3. Add one layer of foam tape insulation from the front of the bin to the front of the base insulation on the left and right side.Manitowoc Ice, Inc.2110 South 26 Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA 8005483Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879 Sheet 1 of 3Web Site - www.manitowocice.com 06/02/003. Add foam tape both sides.2. Install vacuum-formed baseinsulation and align back and sides.