MuxLab VideoEase Installation Manual

Contents

MuxLab VideoEase Installation Manual Manual pdf 9 page image

© MuxLab Inc. VideoEase Active VGA Balun Kit Installation GuidePage 93.3. Pre-Installation ChecklistThere are two components: the transmitter and the receiver.1. The transmitter is connected to the video source, usually a PC, by a VGAjumper cable (not included).2. The transmitter is connected to the receiver by Category 5 (or higher) UTPcable (not included).3. A monitor can be connected to the transmitter by a VGA jumper cable (notincluded).4. The receiver is connected to the display equipment, usually a projector orscreen, by a VGA jumper cable (not included).5. The both transmitter and receiver must be powered by a 12 VDC externalpower supplies (included).6. Verify that the desired image resolution is supported by the VGA source andVGA display.3.4. Installation ProcedureVerify that the distance between the VGA transmitter and receiver are withinMuxLab specifications (see Technical Specifications). In order to install thetransmitter, please follow the steps below:1. Connect the transmitter to the video source with a VGA jumper cable.2. Connect a length of Category 5 (or higher) UTP cable to the transmitter.3. (Optional) Connect a local monitor to the transmitter with a VGA jumper cable.4. Connect the 12 VDC power supply first to the transmitter and then plug thepower supply into an AC power outlet. If power is present, then the greenpower LED will be ON.To install the receiver, please follow the steps below:5. Connect the receiver to the display equipment with a VGA jumper cable.6. Connect the UTP cable to the Video IN/UTP connector of the receiver.