Myson RIO Series Installation Operating And Maintenance Istructions

NOTE: Once saved, the user defined programmesare not lost in the event of a power cut. However,the time will reset to 00:00 and day 1 when thepower returns, if not set, so the product may notheat at the expected times.l Use the “+” or “-” keys to select a userdefinable programme, U1 to U4, to bemodified, then press and hold the “OK”key for 3 seconds.NOTE: If a user defined programme has alreadybeen created and saved, it will be overwrittenwhen the newly defined user programme is saved.l The above screen will be shown, where thesymbol, the time value 00:00, and thetime segment in the programme informationbar along the bottom of the screen will blinkcontinuously.8.4 Standby Model In this mode the radiator isswitched off.l The radiator will no longer receive signalsfrom the TOUCH4 programmer.l At any time, press any key to view themeasured room temperature.l Attention: Please be aware, if there is noheating in your property then your radiatorscould freeze. For the protection of productand property in very low temperatures werecommend the “frost protection” modeis used.8.5 Automatic Mode 8.7 Defining a User Programme11RIORIO10This mode is only to be used whenconnected to a TOUCH4 programmer, orwhen using the built-in programmer.l Please refer to Section 13.NOTE: If the time and day has not been set priorto selecting Automatic mode, you will be promptedto set the time (see section 11, 09 hour: TIMESETTING).8.6 Programme Selection ModeSelecting a Programmel Use the “+” or “-” keys to select one ofthe preset programmes, d1 to d9 (seepage 23), or one of the user definableprogrammes, U1 to U4. The programmenumber will blink. The programme sequencefor the current day is displayed alongthe bottom of the screen. Press the “OK”key to confirm the programme to befollowed.l When confirmed, the control will returnto Automatic.NOTE: If the time and day has not been set prior toselecting Programme Selection mode, you will beprompted to set the time (see section 11, 09 hour:TIME SETTING).l Use the “+” or “-” keys to adjust the time atwhich the first Reduced period will end.l As the time indexes, the blinking segment onthe programme information bar will movehorizontally along the time scale accordingto the time value.l Press the “OK” key to confirm the timeat which the mode will change over fromReduced to Comfort. The symbol will startto blink instead of the symbol, signifyingthe start of this Comfort period.