Setup and Connections ESERV-1xT Serial Servers12 ESERV-1xT (Rev. 1210)3. Configure your serial server as required.Note: For more information on configuration options refer to Section 4: Description ofSerial Server Properties.CONFIGURING THE ESERV-1XT SERIAL SERVER VIA THE SERIAL PORT (CONSOLEMODE)Your serial server can be configured via a serial port using the Ethernet Serial Server Manager. To use this featurethe serial server's serial port must be connected to the serial port of a PC (using a null modem cable).Figure 12. Console Mode SetupTo configure the serial server it must be put into Console Mode, using the Mode switch.To enter Console Mode, press and hold the Mode switch for between two and ten seconds. The LED indicatorsrespond as follows:3. The Ready LED blinks three times per second while the button is being pressed.4. The serial server is in Console Mode when:a. On the ESERV-11T: Port 1 LED is On and the Ready LED is Off.b. On ESERV-12T models: Port 1 LED is On and the Port 2 LED is Off.
