ENGLISHFRANÇAISDEUTSCHESPAÑOLITALIANOPORTUGUÊSSVENSKA15CONFIGURING THE S170iAUDIO SETUPThe Modifications you make on this menu will remain in affect until changed again, or until a Presetcontaining different settings is recalled (see below).DOLBY/DTS SETUPFrom the ] keys,then press [Enter], this will show a sub menu with the following choices to adjust the music modes of theDolby and DTS surround decoders:select or When selected the Panorama setting wraps the sound of the Front Left and Right speakersaround you for an exciting effect.select <1> <2> <3> <4> <5> <6> Center Width allows you to gradually spread the Center channel sound into the Front Left and Rightspeakers. At the widest setting all the Center speaker sound is mixed to the Left and Rightspeakers. This control may help achieve a more spacious sound, or a better blend of the front image.select <0> <1> <2> <3>Dimension adjusts the front/back balance to taste.select <1> <2> <3> <4> Center Image allows you to gradually spread the Center channel sound into the Front Left and Rightspeakers.PRESET SETUPTheS170iincorporatesfive“Presets,”memorylocationsinwhichyoumaystorefivedifferentcombinations of tone-control and relative center/surround/subwoofer channel levels to suit differentrequirements. For example: You might configure Preset 1 for movie-surround with tone controls set tozero and relative channel levels left at their calibrated points, but set Preset 2 for music-surround listeningwith slightly elevated surround- and subwoofer-channel levels, slightly reduced center-channel levels, andmodified bass or treble. Presets may be configured in any way, for any purpose you see fit.CONFIGURING PRESETSFrom the ] and [Enter] keys to select the setup> item. Using the same keys, select the Preset to be configured on the item; then invokethe bass and treble settings desired for that preset using the same keys. With the same keys again, setthe relative levels of Center, Surround, and Subwoofer channels for that preset.NOTE THAT:•If surround-back speaker(s) are configured as present in the OSD menu (below), theirlevels will be controlled along with the surround-channels levels.•Once configured, a Preset remains unchanged until you edit it via the OSD menu.•A Preset applies regardless of what source is selected, or what listening mode is in operation•Cycling the S170i through its Standby mode will cancel any previously selected Preset, reverting bothtone and all level settings to those set on the HTR 2 remote’s LEVELS or MODE/MULTI.S screens(below), or via the S170i preamp’s set all channel-levels and tone-control values to zero without cycling through Standby, set one Presetto “all zeroes.”•Channel levels stored in presets (are added to the setup levels established on the S170i preamp’s OSD menu. For example: if your establishes
at “-3 dB” and
you dial in a Preset center-channel level of +2 dB, the net overall effect will be a center-channel levelof -1 dB. By contrast, tone-control settings override RECALLING PRESETSTo implement the preset at any time, sequentially press the HTR 2’s [AV PRESET] key and thecorresponding numeral key <1 - 5>. Cycling the S170i through Standby mode will release the preset.the number of the preset invoked will appear briefly on the OSD and the S170i’s front-panel display. (Seealso Using Presets, below)
