ENGLISH FRANÇAIS DEUTSCH ESPAÑOL ITALIANO PORTUGUÊS SVENSKA10FRONT PANEL1 POWER: Switch off to disconnect the S170i from all AC power andexit the Standby mode. Switching POWER on both reconnects theAC and actively power-up the preamp.2 STANDBY: Illuminates when the S170i is in the Standby or On mode(dark when the S170i is powered-off).3 AUDIO: Press to select audio inputs sequentially using the VOLUME(SETUP) knob (see “Front Panel Operations,” below).4 VIDEO: Press to select video inputs sequentially using the VOLUME(SETUP) knob (see “Front Panel Operations,” below).5 TAPE MONITOR: Press to engage the Tape Monitor loop. The signalpresent at the rear-panel TAPE MONITOR IN jacks will be heard (see“Front Panel Operations,” below).6 MULTISOURCE: Press to select the signal output by the rear-panelMULTISOURCE OUT jacks using the VOLUME (SETUP) knob (see“Listening in a Remote Zone,” below).7 SPEAKERS: Press to access the menu on the frontpanel readout, and to select parameters using the using the VOLUME(SETUP) knob and subsequent presses of the SPEAKERS key (see“Configuring Your S170i,” and “Front Panel Operations,” below).8 DELAY: Press to access the menu on the front-panelreadout, and to select parameters using the using the VOLUME(SETUP) knob and subsequent presses of the DELAY key (see“Configuring Your S170i,” and “Front Panel Operations,” below).9 LEVELS : Press to access the menu on the front-panelreadout, and to select parameters using the using the VOLUME(SETUP) knob and subsequent presses of the LEVELS key (see“Configuring Your S170i,” and “Front Panel Operations,” below).10 BRIGHTNESS: Press to dim the S170i’s front-panel readout; pressagain to restore full brightness.11 TONE: Press to adjust treble using the VOLUME (SETUP) knob; pressagain to adjust bass, and a third time to exit tone-control adjustment.12 MODE: Press to select listening modes sequentially using theVOLUME (SETUP) knob (see “Setting Listening Modes,” and “FrontPanel Operations,” below).13 VOLUME (SETUP): Turn clockwise to increase the master-volumesetting; counterclockwise to lower it. The VFL and on-screen displaysshow the setting, displayed in decibels between -90 to +16.The VOLUME (SETUP) knob is also used to increment/decrementindividual channel levels and other adjustable parameters.14 VFL DISPLAY: The Vacuum Fluorescent Display provides visualinformation on all of the S170i's important modes, settings, andfunctions for both MAIN and second ZONE locations.