NAD T535 Owner's Manual

Also see for T535: Catalog Specifications Owner's manual

NAD T535 Owner's Manual Manual pdf 16 page image

LEVELFrom [Speaker] menu, scroll to the [Level] option to setup the volume levelsof the individual speakers at a range of 0dB to -12dB.Press to set the desired volume levels for Front L, Center, Front R,Surround L and Surround R speakers or Subwoofer.teSt toneA test tone can be enabled to help you judge the volume level of eachspeaker.1. Scroll to [Test Tone].2. Press to select [Off ], [Manual] or [Auto].off : No test tone outputmanual : Enable test tone manually. During the test tone, you canadjust the volume level while at each channel.auto : Test tone automatically cycles through each channel. Test tonecannot be interrupted and stops only after subwoofer test.3. For [Auto], select [Yes] when the confirmation screen appears.4. For [Manual], press to select each speaker, and then press ENTER tooutput the test tone.reSetThe Speaker Level settings can be reset to their initial factory settings byselecting [On] at the [Reset] option.When [On] is selected, the confirmation screen appears.Select [Yes] to reset the setting, and then press ENTER. The [Level] settingsare now reset to their initial factory settings.Select [Off ] for the settings to remain unchanged.SACD CONFIGURATIONThere are three preset speaker configurations for SACD discs. The followingtable specifies which speakers are set to Large, Small or turned OFF basedon the configuration setting.Speaker SizeConfig 1 Config 2 Config 3Front L/R Large Small LargeCenter Large Small SmallSurround L/R Large Small SmallSubwoofer On On OffCUT-OFF FREQUENCYYou can select a cut-off (cross-over) frequency for all low-frequencysignals. The selectable cut-off frequencies are – 60, 80, 100 and 120(Hz). Allfrequencies below the selected frequency are sent to subwoofer out.OPERATIONuSing the t 535 – Speaker Setup menu16ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙT535_eng_OM_v07.indd 16 16/7/07 08:12:23