NAPCO GEM-DXRP2 Operating Manual

Also see for GEM-DXRP2: Programming instructions

Contents

NAPCO GEM-DXRP2 Operating Manual Manual pdf 6 page image

6S E T T I N G T H E AL AR M ( AR M I N G ) W H E N L E AV I N GZ O N E S F A U L T E D0 2 B A C K D O O RB Y PA SS ED B Y P A S S E DB Y PA SS ED 0 2 B A C K D O O RArming the SystemNote: The keypad will autoscroll messages that are longer than one line.1 Check the keypad. The green STATUS light must be on in order to arm. If thegreen light is off, “FAULT” will display in the window followed by the number ofeach faulted zone. Note each problem zone and secure it by closing a window,door, etc. When all zones are secure, the green STATUS light will turn on and thewindow will display “READY”.Bypass faulted zones. If you cannot locate or repair the problem yourself, callfor assistance. If you cannot get immediate help, bypass the problem zone(s)from the system by pressing B, then the zone number (or vice versa). Note:Bypassed zones are unprotected. If armed with zones bypassed, be sure to havethe system checked as soon as possible.2 Arm the system. Enter your code and press J. The green STATUS light will gooff, the red ARMED light will turn on and the window will alternately display “EXIT"and "XX SEC" (where “XX” represents the exit time remaining, in 10-secondsteps). Note: If you enter an invalid code, the keypad will display “Wrong Code”.3 Leave the premises. Leave through the exit door before exit time expires.A C O NREADYA C O NFAULT/ZONE 02B Y P A S S E D A C O NREADYA C O NEXIT/XX SEC