9Bypassing Interior ZonesInterior Zones, when bypassed, allow free movement within the premises while the protection ofarmed perimeter zones is maintained. If E is pressed, all interior Zones will be bypassed uponarming.(OPTIONAL) Some control panels (such as the GEM-P9600) have provisions for TWO groups of Interior Zones. If two groups of zones wereprogrammed, proceed as follows:1. Select the interior group by repeatedly pressing E. The window will display "INT1". "INT2",or "INT1+2".2. When the desired interior group is displayed, press D to select it. "BYPASSED" and"INTERIOR" will display to indicate interior zones bypassed.3. Enter your code, then press D. The red ARMED light will turn on and the green STATUS lightwill blink, indicating zones bypassed. After the exit time has elapsed, the window will display"ARMED" and "BYPASSED INTERIOR" will be displayed.Automatic Interior Bypass (Optional - Automatic Interior Bypass programmed? YES NO)Your system may have been programmed for Automatic Interior Bypass, which allows it to recognizethat you have armed the system and remained in the house, prompting it to automatically bypassany Interior Zones. In this case, the keypad display will normally show the icon "BYPASSED", ex-cept when the system is armed, and the Exit Entry door is opened. At this time those Interior Zones will unbypass, providing complete interiorprotection.Easy Exit (Optional - Available on systems containing Interior Zones).While the system is armed in the Automatic Interior Bypass state, the Easy Exit option is available. To exit the premises while the system isarmed, press D and the Exit Delay countdown will begin. You can now exit the premises through the Exit/Entry door and the system will returnto the armed state when the countdown expires.P R O T E C T I N G Y O U R S E L F W H I L E O N T H E P R E M I S E SB Y P A S S E D I N T E R I O RA C O NREADYA C O N INT1+2B Y P A S S E D I N T E R I O RA C O NREADYB Y P A S S E D I N T E R I O RA C O NARMEDB Y P A S S E DA C O N READY