BNC-446CNC LATHEOPERATION MANUALNCT Ipari Elektronikai Kft. 73/95 Date: 08.10.2015H-1148 Budapest, Fogarasi út 7.Tel.: +36 1 467 6300www.nct.hu4.4.2. Cross-slideIf the gibs between slide and saddle become loose, it will affect the machining accuracy. Youshould regularly check and adjust them every six months according to the following steps.1. Use flat head screw driver to release the adjust screw 1 about 1/2 circle CCW.2. Tighten screw 2 about 1/2 circle CW.3. Move the slide back and forth to a satisfied smoothness.4.4.3. CarriageIf the gibs between carriage and bed become loose, it will affect the accuracy of carriagetravel. Check and adjust them every six months according to the following steps.1. Use flat head screw driver to loosen the adjust screw 1, 2 as shown in below figure and1/2 circle CCW.2. Appropriately tighten adjust screw 3, 4 as shown in below figure about 1/2 circle CW.3. Move Carriage left and right to a satisfied smoothness.