NComputing X350 User Manual
Also see for X550: Selection guideUser guideUser guideQuick installation guideInstallation
                                                     | |
Contents
| 
X350 and X550 User ManualPage 12Connect Peripheral DevicesConnect each access device to a port on the PCI card using high-quality Cat 5e orshielded Cat 6 cables. These must be standard, straight (not crossover) cables.Maximum cable length between the X-series card and an access device is:Standard Category 5e UTP cable: up to 5 metersStandard Category 6 STP or FTP cable: up to 10 metersWARNING: You must NOT attach any Ethernet networking equipment, such as a hub,switch or router, between the access device and the PCI card. The signals being sentfrom the X350/X550 PCI card to the XD2 device are NOT Ethernet.Connect the desired peripheral devices to each XD2 access device. If you plan to useany USB devices, connect these directly to the host PC – these can then be assigned toeach XD2 station with the vSpace software.Using two screws (provided) you can attach the XD2 to the back of an LCD monitor thathas VESA-compliant mounting holes, as shown below. |
Related manuals for NComputing X550
manualsdatabase
Your AI-powered manual search engine