486. Appendix6-6. SpecificationsModel No.Projection methodPanel resolutionLamp typeScreen sizesContrast ratioLens adjustment functionSignal input terminalExternal ControlPower supply voltageInput currentPower consumptionCooling methodNoise levelInstallationDimensionsNet weightEnvironmentRegulationsNC1600C3 chip DMD reflector method (DLP® method)2048 x 10804.0 kW xenon lamp (Note)5 m to 20 m (Width) (Depends on setup conditions)2200:1 or aboveMotorized lens shift (vertical/horizontal), motorized zoom, motorized focus, douserRGB DIGITAL (2) DVI-D 24pin (TMDS specification)SDI (2) BNC (SMPTE 292M)RS232C (1) D-sub 9 pinRemote controlLAN port (RJ-45) x 2USB port (type A)GPIO port (D-sub 37 pin)PC card slot (1) PCMCIA type II, card busInterlock terminalAC200 to 240V, 50/60 Hz30A5500WCooling fluid system, Cooling air system (includes dust filter)Less than 63 dBOrientation:Desktop/front, Desktop/rear700 mm (W) x 990 mm (D) x 503 mm (H) (Does not include protruding portions Includes foot)99 kg (Excluding lens)Operating temperature: 5 to 35˚COperating humidity: 10 to 85% (non-condensing)Storage temperature: -10 to 50˚CStorage humidity: 10 to 85% (non-condensing) USA UL60950-1 FCC Class ACanada CSA60950-1 ICES-003 Class AEurope EN60950-1 EN55022 Class AEN55024Oceania IEC60950-1AS/NZS CISPR. 22 Class AJapan J60950 VCCI Class AAsia IEC60950-1 CISPR. 22(Note) Using any lamp other than NEC’s optional lamps will result in lower brightness compared to NEC optional lamps. Ifbrightness is important to you, it is recommended that you use NEC’s optional lamps.NEC will post information on its homepage regarding installable lamps, other than NEC’s optional lamps. Note thatNEC does not guarantee performance and reliability when lamps other than NEC’s optional lamps are installed.* Note that these specifications and design can change without prior notice.