NEC DLP CINEMA NC2500S User Manual

Also see for DLP CINEMA NC2500S: Specifications Installation manual

Contents

NEC DLP CINEMA NC2500S User Manual Manual pdf 14 page image

1. What’s in the Box? and the Names of the Projector Parts61-3. Names of the Projector Parts1-3-1. Front of the projector123567481091. Air outletConnects to an exhaust device to exhaust heat from the lamp. Please contact your dealer/distributor to install the exhaust device.2. Control panelOn the control panel, power to your projector is turned on or off, titles are selected, and various adjustments are made ofprojected screen. (See page 10)3. Connection terminalsVarious image signal cable are to be connected here. (See page 9)You can expand signal input terminals by installing an optional multi-media switcher (MMS).4. Main power switchWhile AC power is being supplied, set the main power switch to ON, then your projector will enter a standby state.5. Lens (optional)Images are projected from the lens. Request your dealer/distributor to install or replace the lens.6. Touch panel mounting opening (three position on top)Use the holder arm for the touch panel to attach the touch panel (optional).7. Lamp power cordThis is the power cord that connects with the lamp power supply unit. Request your dealer/distributor to connect/disconnectthe power cord.8. Dedicated interface cableThis is the interface cable that connects with the lamp power supply unit.9. AC power cord (For projector)This is the cord that supplies AC power to the projector head. The AC power cord is not an accessory. Consult with yourdealer/distributor about the AC power cord.10. Interlock connector (Inside front of projector)This is the connector for the projector safety device. This is used to control the projector from an external source. Consultwith your dealer/distributor about using this.NOTE Do not touch the air outlet and backside of the main unit when your projector is operating. Otherwise, the hightemperature may cause burns.