2. Hard Disk Drive OperationsExpress5800/R320e-E4, R320e-M4, R320f-E4, R320f-M4 Maintenance Guide (VMware) 103Chapter 2 Configuring and Upgrading the System2.5.3 Creating and Mounting a FilesystemCreate a file system (VMFS data store) to a RAID device you have built.Important In vSphere version 6.5 or after, support for vSphere Client has been discontinued.To set VMware ESXi, use an item (VMware Host Client, etc.) other than vSphereClient.VMware Host Client uses the Web browser. Therefore, the requirements of the Webbrowser must be met. For details, refer to the following Website.https://docs.vmware.com/en/VMware-vSphere/6.5/com.vmware.vsphere.html.hostclient.doc/GUID-83042A09-281D-4B74-9176-8E882AD23432.htmlImportant If special characters are used for the datastore name, an error may occurunexpectedly. Therefore, do not use special characters for the datastore name. Fordetails, refer to Knowledge Base of VMware.【Knowlede Base of VMware -Troubleshooting issues with VMs or datastore namescontaining special characters (2046088) 】http://kb.vmware.com/kb/2046088Note When configuring RAID device using esxcli storage mpm create command, somedata remains unerased, and the existing VMFS datastore may be displayed on datastorelist. In this case, erase the existing datastore, then create a new datastore.An example of Host Client is shown below.1. Input the URL in the Web browser, connect to the ESXi host, and log in.https:///ui2. Select [Storage] of Navigator, and select the [Datastores] tab.3. Select [New Datastore].
