NEC EXPRESSSCOPE Engine 3 User Manual

Also see for NEC Express5800 Series: User guide User guide User guide User guide Configuration guide

NEC EXPRESSSCOPE Engine 3 User Manual Manual pdf 38 page image

UID Switch ControlYou can turn on/off the UID (Unit ID) LED on the host system by the virtual UID switchthrough the command line interface. This function is available only in the host system withUID LED.NoticeThe user must have an account as administrator for UID SwitchControl (turning on or turning off the UID LED) because of using theset command for the UID Switch Control.Turning on UID LEDEnter the following command at the command prompt. State of the UID LED becomes samestate of turning on the LED by using UID (Unit ID) switch of the host system.set /admin1/system1/led1 ActivateState=2Turning off UID LEDEnter the following command at the command prompt. State of the UID LED becomes samestate of turning off the LED by using UID (Unit ID) switch of the host system.set /admin1/system1/led1 ActivateState=4Confirmation of state of turning on UID LEDEnter the following command at the command prompt.show /admin1/system1/led1You can confirm the state of the UID LED by value of ActivateState of the "Properties" whichis displayed by the command.ActivateState=2 : UID LED state is turned on by UID switch .ActivateState=3 : UID LED sate is blinking by the management software .ActivateState=4 : UID LED state is turned off by UID switch .If the UID LED is not mounted into the host system, the “UID SwitchControl” function works only to the virtual UID LED of the ServerPanel. Please refer to the User’s Guide of your host system for thedescription of the UID LED.- 38 -