3-4 Setting Up Your ServerDo not install the rack in the places listed below. Installing the rack or mounting the server on therack in such a place may cause some malfunction to occur. Narrow space from which devices cannot be pulled out from the rack completely Place that cannot bear the total weights of the rack and devices mounted on the rack Place where stabilizers cannot be installed or where the rack can be installed only after thepractice of proper earthquake-resistant construction Place of uneven or slanting floor Place of drastic temperature change (near a heater, air conditioner, or refrigerator) Place where intense vibration may be generated Place where corrosive gas is generated, chemicals are nearby, or chemicals may beaccidentally sprayed over Place where a carpet not subject to anti-static process is laid. Place where some objects may be fallen on the rack Place near a device generating intense magnetic field (such as a TV, radio,broadcast/communication antenna, power transmission wire, and electromagnetic crane) isplaced (If unavoidable, contact your service representative to request proper shieldconstruction.) Place where the power cord of the server must be connected to an AC outlet that sharesthe outlet of another device with large power consumption. Place near equipment that generates power noise (e.g., contact spark atpower-on/power-off of commercial power supply through a relay). If you must install theserver close to such equipment, request your service representative for separate powercabling or noise filter installation.
