1-10 Before UsingRack-mount ModelWARNINGDo not install the server on a nonconforming rack.Install the server on a 19-inch rack conforming to the EIA standard. Do not use theserver without a rack or install it on a nonconforming rack. The server may not functionproperly, and there is a risk of damage to physical assets or injuries. For suitableracks, contact your sales agent.Do not use the server in an unsuitable place.Do not install a server rack in an unsuitable environment.Other systems also may be affected, and the rack may fall over to cause a fire orinjuries. For details about installation environment and quake-resistant engineering,see the attached manual or contact your sales agent.CAUTIONBe careful not to hurt your fingers.Exercise great care not to hurt your fingers on the rail when you mount/dismount theserver into/from the rack.Carry or install the server by more than 3 people.To avoid a risk of injuries, users should not attempt to carry or install the server into arack. Installation should be performed by trained maintenance personnel.Do not install the server in such a manner that its weight is imposed on a single place.To distribute the weight, use stabilizers or attach two or more racks. Unstable rackmay fall down to cause injuries.Do not assemble parts alone.It takes at least two people to mount doors and trays to a rack. If you handle themalone, you may drop some parts to cause a breakage or injuries.Do not pull a device out of the rack if the rack is unstable.Before pulling out a device, make sure that the rack is fixed (by stabilizers orquake-resistant engineering).Do not leave more than one device pulled out from the rack.If you pull out more than one device, the rack may fall down. You can only pull out onedevice at a time.