NEC Express5800/R310e-E4 Maintenance Manual

Also see for EXP320R: User guide Installation guide Maintenance Guide Maintenance Guide Installation guide

Contents

NEC Express5800/R310e-E4 Maintenance Manual Manual pdf 51 page image

5. Checking the Duplex State of ModulesExpress5800/R310e-E4, R320e-E4, R320e-M4, R310f-E4, R320f-E4, R320f-M4 Maintenance Guide (Windows) 51Chapter 1 Maintenance5.2 Confirming the Startup and Stop of CPU ModulesThis section describes how to confirm the continuous system operation after stopping one of the CPU modules.1. Confirm that the CPU modules are duplex.Tips To check if the CPU modules are duplex, see the System FT LED.Indications of the status LEDs when CPU modules are duplexLED CPU/IO module 0 (Operating) CPU/IO module 1 (Operating)1 PRIMARY LED On (Green) –2 DISK ACCESS LED Blinking (Green)(Lights green when accessing thedisk drive)Blinking (Green)(Lights green when accessing thedisk drive)LED System3 System FT LED On (Green)* The numbers in table above correspond to those shown in figure above.DISK ACCESS LED (2) lights only when hard disk drive is accessed.2. From Start Screen, select ○↓ and ft server utility (or Start – All programs – NEC ESMPRO Agent –ft server utility) to start the ft server utility.3. On the left pane, select the CPU module as follows:- Select CPU module (ID:0) to stop CPU/IO module 0.- Select CPU module (ID:1) to stop CPU/IO module 1.(1)(3)(2)