NEC Express5800/R320f-E4 Installation Manual

Also see for EXP320R: User guide Maintenance Guide Maintenance Guide Maintenance Guide Installation guide

Contents

NEC Express5800/R320f-E4 Installation Manual Manual pdf 73 page image

2. Procedures after Completion of InstallationExpress5800/R320e-E4, R320e-M4, R320f-E4, R320f-M4 Installation Guide (VMware) 73Chapter 1 Installing OS2.3.3 Changing the Firewall Rules on ftSys Management ApplianceThe list of the ports used by ESMPRO/ServerAgent (described as ESMPRO/SA in the table) is shown below.Allow access to these ports to set Firewall in your environment."Auto" in the table enables OS to allocate the available ports within a certain range. Therefore, this cannot befixed. Additionally, "Direction" in the table includes the bi-directional arrows in the top row is at the starting timeof the communication, and the lower shows the communication of return.Function in (Agent) Direction Out (default) NoteServer Monitoring (SNMP) Auto →← 161/udpManager Report (SNMP) Auto → 162/udp Port opening(default)Manager Report (TCP/IP) Auto →← 31134/tcpVia the ManagerExpress Report Service Auto →← 31136/tcpHTTPS (Via the Manager)Express Report Service Auto →← 31138/tcpExpress Report Service(Internet email) Auto→← 25/tcp smtp→← 110/tcp pop3Express Report Service(HTTPS) Auto →← 443/tcp https Port opening(default)Adding New Firewall RulesImportant Do NOT change or delete the default firewall rules. Only add individual rules asnecessary. To handle the Firewall settings, take full responsibility for your actions.Note To enable the firewall rules on ftSys Management Appliance, rebooting ftSys ManagementAppliance is required. Rebooting the ESXi host is not required.1. Add snmp port on ftSys Management Appliance.# firewall-cmd --permanent --add-rich-rule='rule family="ipv4" portport="161" protocol="udp" accept'# firewall-cmd –-reloadReboot ftSys Management Appliance to enable the rules.2.Reboot the guest OS from the Host Client or run the following command on the console.# shutdown -r nowAfter rebooting ftSys Management Appliance, run the following command to make sure that the3.system is running successfully.# /opt/ft/sbin/ft-verify