2. BMC ConfigurationExpress5800/R320e-E4, R320e-M4 Maintenance Guide (Linux)196Chapter 3 Useful Features2.4.4 SNMP AlertThe SNMP Alert menu appears when you select SNMP Alert on BMC Configuration menu.SNMP Alert menuThe table below shows details of parameters and their default value.Item Description Default ValueSNMP AlertSNMP Alert Enable or disable SNMP Alert. *1 DisableComputer Name Specify the Computer Name. *2 BlankCommunity Name Specify the Community Name. *2 PublicAlert Process Select One Alert Receiver or All Alert Receiver for Alert Process. One AlertReceiverAlert Acknowledge Enable or disable Alert Acknowledge. EnableAlert Retry Count Specify the count of Alert retry. *3 3Alert Timeout Specify the timeout period (in seconds) for alert. *3 6Alert Reciever1 Enable or disable primary receiver. *4 EnableIP Address1 Specify the IP Address of primary receiver. *5 0.0.0.0Alert Reciever2 Enable or disable secondary receiver. *4 DisableIP Address2 Specify the IP Address of secondary receiver. *5 0.0.0.0Alert Reciever3 Enable or disable tertiary receiver. *4 DisableIP Address3 Specify the IP Address of tertiary receiver. *5 0.0.0.0Alert LevelAlert Level Specify the kind of event to alert. Error, WarningError: When "Error" is detected in each sensor type, the alert is sent tothe checked address.Error, Warning: When "Error" or "Warning" is detected in each sensor type, thealert is sent to the checked address.Error, Warning, Information: When "Error", "Warning" or "Information" is detected in eachsensor type, the alert is sent to the checked address.Separate Setting: You can arbitrarily select the event to alert in each sensor type.Alert Test Execute a test by SNMP alert. *6 –*1: When PEF (Platform Event Filter) is set to "Disable" in Miscellaneous menu, SNMP alert is disabled.*2: Up to 16 alphanumeric characters are accepted.*3: Can be specified only when Alert Acknowledge is set to "Enable".*4: When SNMP Alert is enabled, at least one alert receiver should be enabled.*5: Can be specified only when each Alert Receiver is set to "Enable".*6: Be sure to perform Alert Test after all the parameters are configured appropriately. Alert feature may faildepending on configuration made for network or alert receiver.
