NEC Express5800 Series Maintenance Manual

Also see for Express5800/B120f: User guide Getting started

Contents

7. Resetting and Clearing the ServerExpress5800/B120f Maintenance Guide46Chapter 1 Maintenance7.3 BMC ResetPress BMC RESET Switch only if a problem occurs in EXPRESSSCOPE Engine 3 (BMC) or you are requestedby your service representative.Do not press this switch in usual operation.Do not turn on/off the server, reboot the system, or perform any switch operation for approximately three minutesafter pressing the BMC Reset switch.Tips  BMC RESET Switch only resets BMC and that does not restart the server. When BMC is reset, network connection from client to BMC is disconnected.Follow the steps below to reset BMC.1. Press ID/BMC RESET Switch for at least eight seconds. The ID LED starts flashing.2. The flashing speed of ID LED becomes slower when you release your finger from ID/BMC RESET Switch.In that state, press ID/BMC RESET Switch again within four seconds.3. BMC Reset starts. While BMC is being reset, STATUS LED lights red. Do not operate the server whileSTATUS LED lights red.After resetting BMC, STATUS LED lights green when the server is powered on, or goes off when theserver is off-powered.ID / BMC RESET Switch