Configuring Your System 3-19Clearing CMOSClear CMOS as follows.1. Power off the system and remove the left side panel as described inChapter 4 of this guide.2. Check to ensure the system power cord is removed from the back of thesystem.3. Remove the spare jumper from position 11 - 12 on jumper block.4. Reinstall the spare jumper on position 1 - 2 (CMOS Clear) of the jumperblock. Refer to Figure 3-1 and Table 3-1 to find the location of this jumper.5. Connect the power cord, power on the system and after POST completes,power down the system and unplug the power cord.6. Remove the jumper from pins 1-2 and store the jumper on pins 11-12.7. Replace the left side panel, connect the power cord and power on thesystem.8. Press F2 at the prompt to run the BIOS Setup Utility, and select “GetDefault Values” at the Exit menu.
