NEC LT10 User Manual
                                    | |
Contents
| 
11EnglishPowering Off the Projector1. Press the “Power” button to turn off the projector lamp.2. After pressing the “Power” button, you will see a message“Power off the lamp?” on the on-screen display. Press the“Power” button again to confirm.Otherwise the message will disappear after 5 seconds.3. Power indicator flashes orange for about 100 seconds. Theprojector will automatically shut itself down.If you want to turn on the projector again, you must press the“Power” button after 100 seconds of the flashing indicator.4. Disconnect the power cord from the electrical outlet and theprojector.5. Do not turn on the projector immediately following apower off procedure.Status Indicator When the Status indicator turns red, it indicates the projector hasoverheated. The projector will automatically shut itself down. When the Status indicator flashes red (0.5 second intervals), itindicates a problem with the lamp. Turn off the projector anddisconnect the power cord from the electrical outlet, then contactyour local dealer or our service center. When the Status indicator flashes red (1 second intervals), itindicates an internal problem. Stop using the projector anddisconnect the power cord from the electrical outlet, thencontact your local dealer or our service center. When the Status indicator flashes orange, it indicates high-speedcooling in progress. This is not an abnormal condition, and you cancontinue using the projector.Installation |
Related manuals for NEC LT10 - XGA DLP Projector
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine