2EnglishImportant InformationPrecautionsFollow all warnings, precautions and maintenance as recom-mended in this user’s guide to maximize the life of your unit.Warning- Do not look into the projector’s lens when the lamp ison. The bright light may hurt your eyes.Warning- To reduce the risk of fire or electric shock, do notexpose this product to rain or moisture.Warning- Please do not open or disassemble the product as thismay cause electric shock.Warning- When changing the lamp, please allow unit to cooldown, and follow all changing instructions.Warning- This product will detect the life of the lamp itself.Please be sure to change the lamp when it showswarning messages.Warning- Reset the “Clear Lamp Hours Meter” function from theOn Screen Display “Setup” menu after replacingthe lamp module (refer to page 22).Warning- When switching the projector off, please ensure theprojector completes its cooling cycle beforedisconnecting power.Warning- Turn on the projector first and then the signal sources.Warning- When the lamp reaches the end of its life, it will burnout and may make a loud popping sound. If thishappens, the projector will not turn back on until thelamp module has been replaced. To replace thelamp, follow the procedures listed under “Changingthe Lamp”.WARNING TO CALIFORNIA RESIDENTS:Handling the cables supplied with this product, will expose you to lead, achemical known to the State of California to cause birth defects or otherreproductive harm. Wash hands after handling.