NEC M155 User Manual

NEC M155 User Manual Manual pdf 13 page image

Regulatory information U SA13Regulatory information USAFCC informationThis device complies with Part 15 of the FCC Rules. Operation issubject to the following two conditions: (1) this device may not causeharmful interference, and (2) this device must accept any interferencereceived, including interference that may cause undesired operation.This equipment has been tested and found to comply with the limits fora Class B digital device, pursuant to Part 15 of the FCC Rules. Theselimits are designed to provide reasonable protection against harmfulinterference in a residential installation. This equipment generates, usesand can radiate radio frequency energy and, if not installed and used inaccordance with the instructions, may cause harmful interference toradio communications. However, there is no guarantee that interferencewill not occur in a particular installation. If this equipment does causeharmful interference to radio or television reception, which can bedetermined by turning the equipment off and on, the user is encouragedto try to correct the interference by one or more of the followingmeasures:Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiver.Connect the equipment into an outlet on a circuit different from thatto which the receiver is connected.Consult the dealer or an experienced radio/TV technician for help.Modifications not expressly approved by NEC could void the user'sauthority to operate the equipment.Privacy of communications may not be ensured when using thisequipment.Exposure to Radio Frequency (RF) Signals:This wireless phone is a radio transmitter and receiver. It is designedand manufactured not to exceed the emission limits for exposure toradio frequency (RF) energy set by the Federal CommunicationsCommission (FCC) of the U.S. Government. These limits are part ofcomprehensive guidelines and establish permitted levels of RF energyfor the general population. The guidelines are based on the safetystandards previously set by both U.S. and international standards