NEC MD242C2 Installation And Maintenance Manual

Also see for MD242C2: Installation & maintenance guide

NEC MD242C2 Installation And Maintenance Manual Manual pdf 13 page image

English-11EnglishFigure S.1Flexible Arm InstallationThis LCD monitor is designed for use with a fl exible arm.To prepare the monitor for alternate mounting purposes:• Follow the instructions provided by the manufacturer of the monitor mount.• To meet the safety requirements, the monitor must be mounted to an arm that supports the weight of the monitor.See page 26 for details. Remove the monitor stand before mounting.Remove the Monitor Stand for MountingTo prepare the monitor for alternate mounting purposes:1. Disconnect all cables.2. Place hands on each side of the monitor and lift up to the highest position.3. Place the monitor face down on a non-abrasive surface. Be sure to not apply anystress or pressure to the integrated front sensor. To avoid this, lay the monitorface down on a desk or table with the integrated front sensor situated off theedge (Figure S.1).4. Place one hand around the base and one hand on the Quick Release Lever.Push and hold the Quick Release Lever in the direction indicated by thearrows (Figure S.1).5. Lift up the stand to unhook it from the monitor (Figure S.1).The monitor can now be mounted using an alternate method.Reverse process to reattach stand.NOTE: Handle with care when removing the monitor stand.Mount Flexible armThis LCD monitor is designed for use with a fl exible arm.1. Follow the instructions on how to Remove the Monitor Stand for Mounting to remove the stand.2. Use the 4 screws and attach the arm to the monitor (Figure F.1).Caution: Use ONLY the screws (4 pcs) that are included or the screws M4 size(Length: thickness of bracket and washer + 10-12 mm) when mounting toavoid damage to the monitor and stand. To fulfi l the safety requirements themonitor must be mounted to an arm which guaranties the necessary stabilityunder consideration of the weight of the monitor. The LCD monitor should only beused with an approved arm (e.g. GS mark).Mounting BracketScrewWasherUnit10-12 mmThickness of bracketand washerNOTE: Tighten all screws.(The recommended torque is 0.98 - 1.37N•m)100 mm100 mmFigure F.1Weight of LCD assembly: 6.8 kg