NEC MDview 243 User Manual

Also see for MDview 232: Manual User guide

English-14HOT KEYYou can adjust the BRIGHTNESS directly. When this function is set to ON, you can adjust the brightness with “Left” or“Right”, while the OSD menu is off. The standard OSD can be accessed with the EXIT button. When this function is setto OFF, some buttons are disabled (see page 9).FACTORY PRESETSelecting Factory Preset allows you to reset all OSD control settings (BRIGHTNESS, CONTRAST*1, ECOMODE,BLACK, IMAGE CONTROL, COLOR CONTROL SYSTEM, SHARPNESS, PIP MODE, PIP INPUT, PIP LEFT/RIGHT,PIP DOWN/UP, PIP SIZE, USB SELECTION, EDID EXTENSION, OFF TIMER, OFF MODE, OSD LEFT/RIGHT,OSD UP/DOWN, OSD TURN OFF, OSD TRANSPARENCY) back to the factory settings. Individual settings can bereset by highlighting the control to be reset and pressing the RESET button.NOTE: If you want reset to include the Picture calibration settings and SELF COLOR CORRECTION settings,please use Factory Preset in the Advanced OSD menu (see page 22).ECO InformationCARBON SAVINGS: Displays the estimated carbon savings information in kg.CARBON USAGE: Displays the estimated carbon usages information in kg.This is the arithmetic estimation, not actual measurement value.This estimation is based without any options.COST SAVINGS: Displays the electricity cost savings in balance.CARBON CONVERT SETTING: Adjusts the carbon footprint factor in the carbon saving calculation. This initial settingis based on the OECD (2008 Edition).CURRENCY SETTING: Displays electricity pricing (available in 6 currency units).CURRENCY CONVERT SETTING: Allows for localization of the electricity costs for accurate information in theelectrical rate savings.NOTE: This model’s initial setting is Currency = US$ and its Currency Convert setting = $0.11.This setting can be changed by using the ECO information menu.If you want to use the French setting, please refer to steps below:1. Open menu by pressing the Menu button and select the ECO information menu using the left or right key.2. Select Currency setting item pressing the Up or Down key.3. The French currency unit is Euro ( ). You can adjust currency setting to Euro icon ( ) from US dollar ($)using the Left or Right key in Current setting item.4. Select Currency Convert Setting item using the Up or Down key.This initial Euro ( ) setting is Germany of OECD (2007 Edition).Please check receipt of French’s electricity prices or OECD data for France.France of OECD (2007 Edition) was 0.12.5. Adjust Currency Convert Setting item using the Right or Left key.InformationProvides information about the current resolution display (Main picture), current USB input setting and technical dataincluding the preset timing being used and the horizontal and vertical frequencies. Indicates the model and serialnumbers of your monitor.OSD WarningOSD Warning menus disappear with EXIT button.NO SIGNAL: This function gives a warning when there is no Horizontal or Vertical Sync. After power is turned on orwhen there is a change of input signal, the No Signal window will appear.RESOLUTION NOTIFIER: This function warms if resolution other than the optimized resolution is used. After power isturned on or when there is a change of input signal or the video signal doesn’t have proper resolution, the ResolutionNotifier window will open. This function can be disabled in the MENU Tools.OUT OF RANGE: This function gives a recommendation of the optimized resolution and refresh rate. After the poweris turned on or there is a change of input signal or if the video signal doesn’t have proper timing, the Out Of Rangemenu will appear.INTERLACED SIGNALS ARE NOT SUPPORTED: This function gives a warning when the interlace signal is used.While the image is visible, change the signal of the device from interlaced to progressive (non-interlaced).See “No Picture” in Troubleshooting for detailed information.If you need detailed information about the controls, please use the ADVANCED OSD menu.*1 MDview 232/243 only.