NEC MultiSync C431 User Manual

Also see for MultiSync C431: User manual User manual Installation guide

Contents

NEC MultiSync C431 User Manual Manual pdf 16 page image

(16/104)5.3 Set parameterSend this message to change monitor’s adjustment and so on.The controller requests a monitor to change value.1stbyte) STX: Start of MessageASCII STX (02h)2nd-3rdbytes) OP code page: Operation code pageThis OP code page data must be encoded to ASCII characters.Ex.) The byte data 02h must be encoded to ASCII '0' and '2' (30h and 32h).Refer to the Operation code table.4th-5thbytes) OP code: Operation codeThis OP code data must be encoded to ASCII characters.Ex.) OP code 1Ah -> OP code (Hi) = ASCII '1' (31h)OP code (Lo) = ASCII 'A' (41h)Refer to the Operation code table.6th-9thbytes) Set value: (16bit)This data must be encoded to ASCII characters.Ex.) 0123h -> 1st(MSB) = ASCII '0' (30h)2nd = ASCII '1' (31h)3rd = ASCII '2' (32h)4th(LSB) = ASCII '3' (33h)10thbyte) ETX: End of MessageASCII ETX (03h)STX OP codepageOP code Set Value ETXHi Lo Hi Lo MSB LSB1st 2nd-3rd 4th-5th 6th-9th 10th