NEC MultiSync C431 User Manual

Also see for MultiSync C431: User manual User manual Installation guide

Contents

NEC MultiSync C431 User Manual Manual pdf 6 page image

(6/104)III. Communication specification3. Communication Parameter3.1 RS-232C Remote control(1) Communication system Asynchronous(2) Interface RS-232C(3) Baud rate 9600bps(4) Data length 8bits(5) Parity None(6) Stop bit 1 bit(7) Communication code ASCII3.2 LAN control(1) Communication system TCP/IP (Internet protocol suite)(2) Interface Ethernet (CSMA/CD)(3) Communication layer Transport layer (TCP)* Using the payload of TCP segment.(4) IP address (Default) Automatic setup* If you need to change,Please refer “Network settings” on User’s manual.(5) Port No. 7142 (Fixed)(Note)The monitor will disconnect the connection if no packet data is received for 15 minutes.And the controller (PC) has to re-connect to control the monitor again, after 15 minutes ormore.3.3 Communication timingThe controller should wait for a reply packet before the next command is sent.(Note)When the following commands are sent, a controller should wait for specified period afterreceiving the reply command before sending the next command. Power On, Power Off: 15 seconds Input, Auto Setup, Factory Reset: 10 seconds