NEC MultiSync LCD1770GX User Manual

Also see for LCD1770GX-BK: Specifications Specifications

NEC MultiSync LCD1770GX User Manual Manual pdf 17 page image

15Monitor MultiSync ® LCD1770GX NotesSpecifications MonitorLCD Module Diagonal : 17.0 inch Active matrix; thin film transistor (TFT)Viewable Image Size : 17.0 inch liquid crystal display (LCD); 0.264 mm dotNative Resolution (Pixel Count) : 1280 x1024 pitch; 400cd/m2 white luminence;500:1 contrast ratio, typicalInput Signal Video : ANALOG 0.7 Vp-p/75 Ohms Digital Input: DVI-DSync : Separate sync. TTL Level Positive/NegativeHorizontal sync. Positive/NegativeVertical sync. Positive/NegativeComposite sync. Positive/Negative* 2Sync on Green ( 0.3Vp-p Negative 0.7Vp-p Positive)* 2Display Colors 16,194,277 Dependent on display card used.Maximum Left/Right : 80°/80° (CR>5)Viewing Angles Up/Down : 80°/80° (CR>5)Synchronization Horizontal : 31.5 kHz to 81.0 kHz (Analog) AutomaticallyRange 31.5 kHz to 69.0 KHz (Digital)Vertical : 56.0 Hz to 75.0 Hz AutomaticallyResolutions Supported 720 x 400* 1 @ 70 Hz Some systems may not support all modes listed.640 x 480* 1 @ 60 Hz to 75 Hz800 x 600* 1 @ 56 Hz to 75 Hz832 x 624* 1 @ 75 Hz1024 x 768* 1 @ 60 Hz to 75 Hz1152 x 864* 1 @ 75 Hz1152 x 870* 1 @ 75 Hz1280 x 1024 @ 60 Hz to 75 Hz (Analog).....NEC-Mitsubishi Electronics1280 x 1024 @60 Hz (Digital) Display citesrecommended resolutionat 60 Hz for optimal displayperformance.Active Display Area Horizontal : 337.9 mm/13.3 inchesVertical : 270.3 mm/10.6 inchesUSB Hub I/P: USB Specification Revision 2.0Port: Upstream 1Downstream 4Load Current: Maximum 0.5A per portPower Supply 100 – 240 V~ 50/60 HzCurrent Rating 0.94 - 0.47 ADimensions 367 mm (W) x 362.5-472.5 mm (H) x 198.0 mm (D)14.4 inches (W) x 14.3-18.6 inches (H) x 7.8 inches (D)Weight 6.1 kg13.4 lbsEnvironmental ConsiderationsOperating Temperature : 5°C to 35°C/41°F to 95°FHumidity : 30% to 80%Feet : 0 to 10,000 FeetStorage Temperature : -10°C to 60°C/-14°F to 140°FHumidity : 10% to 85%Feet : 0 to 30,000 Feet* 1 Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This isnormal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel technologies, eachdot on the screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.* 2 If your display is not showing a picture of the SOG and Composite sync. signal, please contact our hotline for assistance.NOTE: Technical specifications are subject to change without notice.SpecificationsLCD1770GXManual011305.pmd 1/14/05, 5:04 PM15