NEC MultiSync LCD1850X User Manual

Contents

AccuColor ® Control SystemsAccuColor ® Control Systems: Six color presets select the desired color setting(sRGB and NATIVE color presets are standard and cannot be changed). Colortemperature increases or decreases, in each preset. R,Y,G,C,B,M,S: Increasesor decreases Red, Yellow, Green, Cyan, Blue, Magenta and Saturationdepending upon which is selected. The change in color will appear on screenand the direction (increase or decrease) will be shown by the color bars.NATIVE: Original color presented by the LCD panel that is unadjustable.sRGB: sRGB mode dramatically improves the color fidelity in the desktopenvironment by a single standard RGB color space. With this color supportedenvironment, the operator could easily and confidently communicate colorwithout further color management overhead in the most common situations.Tools 1SMOOTHING: Select one of three image sharpness settings. This function isonly valid when the expanded display function (expansion function)is on.TEXT MODE: Use this to display text clearly.NORMAL MODE: This sharpness is between TEXT and GRAPHIC MODE.GRAPHIC MODE: This mode is suited for images and photographs.EXPANSION MODE: Sets the zoom method.FULL : The image is expanded to 1280 x 1024, regardless of the resolution.ASPECT: The image is expanded without changing the aspect ratio.OFF: The image is not expanded.CUSTOM (DIGITAL INPUT & RESOLUTION OF 1280x1024 ONLY): Selectone of seven expansion rates. In this mode the resolution may be low andthere may be blank areas. This mode is for use with special video cards.VIDEO DETECT: Selects the method of video detection when more than onecomputer is connected.FIRST DETECT: The video input has to be switched to “FIRST DETECT”mode. When current video input signal is not present, then the monitorsearches for a video signal from the other video input port. If the videosignal is present in the other port, then the monitor switches the videosource input port to the new found video source automatically. Themonitor will not look for other video signals while the current videosource is present.LAST DETECT: The video input has to be switched to the “LAST DETECT”mode. When the monitor is displaying a signal from the current sourceand a new secondary source is supplied to the monitor, then the monitorwill automatically switch to the new video source. When current videoinput signal is not present, then the monitor searches for a video signalfrom the other video input port. If the video signal is present in the otherport, then the monitor switches the video source input port to the newfound video source automatically.NONE: The Monitor will not search the other video input port unless themonitor is turned on.DVI SELECTION: This function selects the DVI input mode. When the DVIselection has been changed, you must restart your computer.DIGITAL: DVI digital input is available.ANALOG: DVI analog input is available.8Controls –continued01.4.2, 5:03 PM10