NEC MultiSync LCD1850X User Manual

Contents

NEC MultiSync LCD1850X User Manual Manual pdf 14 page image

English-3EnglishQuick StartTo attach the MultiSync LCD monitor to your system, follow theseinstructions:1. Turn off the power to your computer.2. For the PC or Mac with DVI digital output: Connect the DVI-D toDVI-D signal cable to the connector of the display card in yoursystem (Figure A.1). Tighten all screws.For the PC with Analog output: Connect the 15-pin mini D-SUB toDVI-A signal cable to the connector of the display card in your system(Figure A.2).For the Mac: Connect the MultiSync Macintosh cable adapter to thecomputer (Figure B.1). Attach the 15-pin mini D-SUB signal cable tothe MultiSync Macintosh cable adapter (Figure B.1).NOTE: Some Macintosh systems do not require a Macintosh cableadapter.3. Remove connector cover. Connect the DVI signal cable to theconnector on the back of the monitor. Place the video signal cable(Figure C.1).Replace connector cover.NOTE: Incorrect cable connections may result in irregular operation,damage display quality/components of LCD module and/orshorten the module’s life.4. Connect one end of the power cord to the AC inlet on the back of themonitor and the other end to the power outlet (Figure D.1).NOTE: Please refer to Caution section of this manual for properselection of AC power cord.5. Check the Vacation Switch on the right hand side of the monitor is inthe ON position. Turn on the monitor with the Power Button(Figure E.1) and the computer.NOTE: There are two switches: one on the right side and one on thefront side of the monitor. DO NOT switch on/off quickly.01b_English 2/4/01, 3:39 pm3