NEC MultiSync LCD1970VX User Manual

Also see for MultiSync LCD1970NX: Specifications Specifications Specifications Brochure & specs Specifications

NEC MultiSync LCD1970VX User Manual Manual pdf 11 page image

EnglishEnglish-3Quick StartTo attach the MultiSync LCD monitor to your system, follow these instructions:1. Turn off the power to your computer.2. For the PC or MAC with DVI digital output: Connect the DVI signal cable (not included) to the connector of the displaycard in your system (Figure A.1). Tighten all screws.For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the connector of the display card in yoursystem (Figure A.2). Tighten all screws.For the MAC: Connect the Macintosh cable adapter to the computer, then attach the 15-pin mini D-SUB signal cable tothe Macintosh cable adapter (Figure B.1). Tighten all screws.NOTE: Some Macintosh systems do not require a Macintosh cable adapter.3. Place hands on each side of the monitor to tilt the LCD panel 30-degree angle and lift up to the highest position (Figure C.1).4. Connect all cables to the appropriate connectors (Figure C.1).5. Place power cord into the specific hooks indicated in Figure C.2.6. Place the D-Sub into the specific hooks indicated in Figure C.2.Figure A.1 Figure B.1MacintoshCable Adapter(not included)Figure A.2DVI signal cable(not included)HighestStandPositionDVI Cable (not included)30˚ TiltD-SUB CablePower CordFigure C.1 Figure C.2DC-OUT (NX/NXp only)NEC optional product attachment.Do not use this connector unless specified.01_English 13/4/06, 9:233