NEC MultiSync LCD1980SX User Manual

Also see for LCD1980SX - MultiSync - 19" LCD Monitor: Brochure User manual Dimensions Supplementary guide User manual

NEC MultiSync LCD1980SX User Manual Manual pdf 14 page image

English-6ControlsOSM (On-Screen Manager) control buttons on the front of the monitorfunction as follows:To access OSM menu, press any of the control buttons (EXIT, , , –, +).To change signal input, press the SELECT button.NOTE: OSM must be closed in order to change signal input.NOTE: When RESET is pressed in the main and sub-menu, a warning window will appear allowing you to cancel theRESET function by pressing the EXIT button.Brightness/Contrast ControlsBRIGHTNESSAdjusts the overall image and background screen brightness.CONTRASTAdjusts the image brightness in relation to the background.AUTO CONTRAST (Analog input only)Adjusts the image displayed for non-standard video inputs.AUTO BRIGHTNESSThis function adjusts the brightness automaticaly for the best BRIGHTNESS setting based on the whitedisplay area.Auto Adjust (Analog input only)Automatically adjusts the Image Position and H. Size (or V. Size) settings and Fine settings.Image ControlsLEFT / RIGHTControls Horizontal Image Position within the display area of the LCD.DOWN / UPControls Vertical Image Position within the display area of the LCD.H. SIZE (OSD ROTATION: Landscape) orV. SIZE (OSD ROTATION: Portrait) (Analog input only)Adjusts the horizontal (or vertical) size by increasing or decreasing this setting.If the “Auto Adjust function” do not give you a satisfactory picture setting, a further tuning can be performedmanually using the “H. Size (or V. Size)” function (dot clock). For this a Moiré test pattern could be used.This function may alter the width of the picture. Use Left/Right Menu to center the image on the screen.If the H. Size (or V. Size) is wrongly calibrated, the result would look like on the left drawing. The imageshould be homogeneous.MenuExits the OSM controls.Exits to the OSM main menu.Moves the highlighted area left/right to select control menus.Moves the highlighted area up/down to select one of the controls.Moves the bar left/right or changes the adjustment value to increase or decrease the adjustment.Activates the selected function. Enter the OSM controls. Enter the OSM sub menu.Select input while OSM disappeared.Resets the highlighted control menu to the factory setting.EXITCONTROL /ADJUST - / +SELECTRESETWhen H. SIZE value iswrong.When H. SIZE value isimproved.When H. SIZE value iscorrect.01_English 7/21/03, 3:42 PM6