EnglishEnglish-5TiltGrasp top and bottom sides of the monitor screen with yourhands and adjust the tilt as desired (Figure TS.1).Figure TS.1Figure S.1SwivelGrasp both sides of the monitor screen with your handsand adjust the swivel as desired (Figure TS.2).NOTE: Handle with care when tilting the monitor screen.Remove Monitor Stand for MountingTo prepare the monitor for alternate mounting purposes:1. Disconnect all cables.2. Place hands on each side of the monitor and lift up to the highest position.3. Place monitor face down on a non-abrasive surface. (Place the screen on a 25 mm platform so that the stand is parallelwith the surface) (Figure S.1).4. Remove the two top screws connecting the monitor to the stand (Figure S.2). Turn the stand to 180° counterclockwise(you will hear two clicks). Remove the screws from the bottom (Figure S.3) and lift off the stand. The monitor is now readyfor mounting in an alternate manner.5. Reverse this process to reattach stand: tighten the two bottom screws, turn stand 180° counter clockwise (you will heartwo clicks), and tighten two top screws.NOTE: Use only VESA-compatible alternative mounting method (100 mm pitch).NOTE: Handle with care when removing monitor stand.Figure S.2Caution: Use the original screws (4 pcs) when mounting to avoid damage to the monitor and stand. To fulfil the safetyrequirements the monitor must be mounted to an arm which guaranties the necessary stability under considerationof the weight of the monitor. The LCD monitor should only be used with an approved arm (e.g. GS mark).25 mmFigure TS.2Figure S.301_English 18/11/2002, 13:065