NEC MultiSync LCD2080UX LCD2080UX LCD2080UX User Manual

Also see for LCD2080UX - MultiSync - 20.1" LCD Monitor: User manual Brochure Supplementary guide Dimensional drawing User manual

NEC MultiSync LCD2080UX LCD2080UX LCD2080UX User Manual Manual pdf 15 page image

EnglishEnglish-7FINE (Analog input only)Improves focus, clarity and image stability by increasing or decreasing this setting.Should the “Auto Adjust function” and the “H.Size” function do not give you a satisfactory picture setting, afine tuning can be performed using the “Fine” function. It improves focus, clearity and image stability byincreasing or decreasing this setting.For this a Moiré test pattern could be used. If the Fine value is wrongly calibrated, the result would look likeon the left drawing. The image should be homogeneous.Color Control SystemsColor Control Systems: Six colour presets select the desired colour setting (sRGB and NATIVE colourpresets are standard and cannot be changed). Colour temperature increases or decreases, in each preset.R,Y,G,C,B,M,S: Increases or decreases Red, Yellow, Green, Cyan, Blue, Magenta and Saturationdepending upon which is selected. The change in colour will appear on screen and the direction (increaseor decrease) will be shown by the colour bars.NATIVE: Original colour presented by the LCD panel that is unadjustable.Tools 1SHARPNESS: This function is digitally capable to keep crisp image at any timings. It is continuouslyadjustable to get distinct image or soft one as you prefer, and set independently by different timings.The number of adjustment steps is different depending on whether EXPANSION Mode is OFF, FULL orASPECT (1600 x 1200 is OFF Mode).EXPANSION MODE: Sets the zoom method.FULL: The image is expanded to 1600 x 1200, regardless of the resolution.ASPECT: The image is expanded without changing the aspect ratio.OFF: The image is not expanded.CUSTOM (Digital input and Resolution of 1600 x 1200 only):Select one of nine expansion rates. In this mode the resolution may be low and there maybe blank areas. This mode is for use with special video cards.VIDEO DETECT: Selects the method of video detection when more than one computer is connected.FIRST DETECT: The video input has to be switched to “FIRST DETECT” mode. When current videoinput signal is not present, then the monitor searches for a video signal from the other video input port.If the video signal is present in the other port, then the monitor switches the video source input port tothe new found video source automatically. The monitor will not look for other video signals while thecurrent video source is present.LAST DETECT: The video input has to be switched to the “LAST DETECT” mode. When the monitor isdisplaying a signal from the current source and a new secondary source is supplied to the monitor,then the monitor will automatically switch to the new video source. When current video input signal isnot present, then the monitor searches for a video signal from the other video input port. If the videosignal is present in the other port, then the monitor switches the video source input port to the newfound video source automatically.NONE: The Monitor will not search the other video input port unless the monitor is turned on.DVI SELECTION: This function selects the DVI input mode (Input 1). When the DVI selection has beenchanged, the computer has to be restarted.AUTO: By using the DVI-D to DVI-D cable, the DVI SELECTION is DIGITAL.By using the D-SUB to DVI-A cable, the DVI SELECTION is ANALOG.DIGITAL: DVI digital input is available.ANALOG: DVI analog input is available.Note: Depending on the PC and Video card used, or when another Video signal cable is attached, thisfunction may not operate.OFF TIMER: Monitor will automatically power-down when the end user has selected a pre-determinedamount of time.When FINE value iswrong.When FINE value iscorrect.01_English 18/11/2002, 13:067