Top Features1 Power ButtonUse this button to turn the power on and off when Main Power Switch ison and the projector is on standby.2 Enter ButtonExecutes your menu selection.3 Select (stß ©) / (+)(–) ButtonsSelect: After you press the “Menu” button, use the s or t button toselect the menu icon of the item you wish to adjust.(+)(–): Use these buttons while you' re in the Image Adjust mode tochange the level of a selected menu item. These buttons are alsoused to set an item in the Power or Settings menus.4 Menu ButtonDisplays the on- screen menu.5 Power IndicatorWhen the projector is switched On, the green LED blinks for about oneminute, then lights up.19INTRODUCTION 20If the main power is on and you switch it off by pressing POWEROFF on the remote control or press and hold down the POWERbutton on the cabinet for one second, the green LED blinks forone minute, then lights up and the projector goes on standby.* The projector will not accept operation instructions for the oneminute during which the LED is blinking during switching onor off as described above.6 Status IndicatorWhen this is lit red continually, it's warning you that the projec-tion lamp has exceed 1000 hours of service. After this light ap-pears, it is advisable to replace the projection lamp as soon aspossible.(See page 77.)When the operating time of the lamp exceeds 1000 hours, the STA-TUS indicator is lit red continually. In addition the message "LAMPUSAGE XX HOURS" appears continually when the on-screenmenu is not displayed.If this light blinks red rapidly, it indicates that the lamp house isnot attached properly; if the light blinks slowly it means the pro-jector's internal temperature is too hot to operate safely. See theStatus Light Messages on page 85 for more details.(stß ©)MENUSELECT- +ENTERSTATUSPOWERON / OFF432651AC INMEMUSELECTENTERSTATUSPOWERON / OFF