NEC MultiSync LT 100 User Manual

Also see for LT100 - MultiSync XGA DLP Projector: Compatibility chart User manual Installation data

NEC MultiSync LT 100 User Manual Manual pdf 19 page image

Using A Tabletop Or Cart1. Place your projector on a flat level surface at the optimal distancefrom the screen or wall so you realize the size image you want.(Avoid having bright room lighting or sun light directly on thescreen or wall where you'll be projecting the image.)2. Connect the power cable, remove the lens cap and turn the projectoron. (If no input signal is available, the projector will display abackground image.)3. Ensure that the projector is square to the screen.4. Move the projector left or right to center the image horizontally onthe screen. (A)5. To center the image vertically (B), lift the front edge of the projectorand press the buttons on the front of the projector, just above thefeet, to release the one-touch tilt feet. (There is approximately 5.0˚of up and down adjustment for the front of the projector.35(A) Top view(B) Side viewscreenINSTALLATION 366. To fine tune the image's position vertically on the screen, rotate eachfront foot, and rear feet if necessory.NOTE: Adjust feet so that lens surface is parallel to the screen.If you use the projector with the screen tilted, the picture will bedistorted.7. Adjust the size of the image using the zoom ring lever on the lens.NOTE: The set up angle of the projector should not exceed 15degrees, otherwise lamp life could decrease dramatically.screenUp DownFocus ringZoom ring leverUp Down