NEC MultiSync MT830+ User Manual

NEC MultiSync MT830+ User Manual Manual pdf 25 page image

Connecting Your PC Or MacintoshComputerConnecting your PC or Macintosh computer to your MultiSyncMT830 (SVGA) /1030 (XGA) Projector will enable you to projectyour computer's screen image for an impressive presentation. All ofthese following display standards are supported:To connect to a PC, Macintosh or computer equipped with an XGA/SVGA /VGA adapter or compatible graphics adapter, simply:1. Turn off the power to your projector and computer.2. If your PC does not support XGA/SVGA/VGA you will need toinstall an XGA/SVGA/VGA graphics board. Consult yourcomputer's owner's manual for your XGA/SVGA/VGA configura-tion. If you need to install a new board, see the manual that comeswith your new graphics board for installation instructions.VGA 6402480 for graphics VGA 6402400 for graphicsVGA 6402350 for graphics VGA 7202400 for textVGA 7202350 for text SuperVGA 8002600Macintosh at 6402480 Macintosh at 8322624XGA10242768 Macintosh at 10242768SXGA128021024 (AccuBlend)Settings for Monitor ModeNumber of DIP switchMonitor size15” multi-scan mode /16”–13”17” multi-scan mode /19”–13”19” multi-scan mode /21”–13”13” fixed mode /6402480VGA/SVGA mode16” fixed mode /832262419” fixed mode /10242768S1ONONONONS2 S3 S4ONS5ONONS6ONS7ONS8ONNOTE: For settings other than display modes supported by yourMacintosh and MT830/1030, use of the DIP switch may bounce a imageslightly or may display nothing. If this happens, set the DIP switch to the13” fixed mode and then restart your Macintosh. After that, restore to adisplayable mode and then restart the Macintosh again.Make sure that the MT830/1030 and your Macintosh are connected withthe pin adapter and the supplied signal cable (mini D-Sub 15-pin connec-tor) and then restart your Macintosh.3. Use the signal cable that's supplied to connect your PC orMacintosh computer to the projector. For a Macintosh, use thesupplied pin adapter to connect to your Mac's video port.4. Turn on the projector and the computer.5. If the projector goes blank after a period of inactivity, it may becaused by a screen saver installed on the computer you'veconnected to the projector.When using a Macintosh with the MT830/1030, set the DIPswitches of the supplied pin adapter according to your resolution.After setting, restart your Macintosh.See the following pages for setting of the DIP switches.• When using with a Macintosh, XGA/VGA/SVGA is recom-mended if your Macintosh supports this mode.• When using with a Macintosh PowerBook, output may not beset to 10242768 unless “mirroring” is off on your PowerBook.Refer to owner’s manual supplied with your Macintosh com-puter for mirroring.NOTE: A Video Adapter cable manufactured by Apple Computeris needed for a PowerBook which does not have a mini D-Sub 15-pin connector.INSTALLATION4748