NEC MultiSync MT830+ User Manual

NEC MultiSync MT830+ User Manual Manual pdf 30 page image

This section describes how to select a computer or video source and how to adjustthe picture and sound.General Controls Before you turn on your MultiSync MT830/1030 LCD Projec-tor, ensure that the computer or video source is turned on and that your lens cap isremoved.1. Turn On The LCD Projector The main power switch is on the front panel ofthe MultiSync MT830/1030 LCD Projector. By turning this switch on, theprojector will go into its standby mode and the power light will glow amber.Only after you press the "On" button on the remote control or projector cabinetwill the power light turn to green and the projector become ready to use.NOTE: To turn the LCD projector on and off with just the front panel switch,use the menu and enable the "auto start" feature. (See page 67. )2. Select The Computer, Video Source Or “Presentation Viewer” Press the“Video” (VCR, document camera, or laser disc player), “S-video”, “RGB 1” or“RGB 2” (computer) or PC CARD button on the remote control to display theimage. Or press the “Menu” button on the cabinet and use the icons to selectyour video source: “Video”, “S-Video”, “RGB 1”, “RGB 2” or “PC CARD”.O P E R A T I O N33. Adjust The Image Size Press the "Zoom" button (+) or (-) on the remote controlor projector cabinet to make the image larger or smaller.4. Focus Press the "Focus" button (+) or (-) on the remote control or projectorcabinet to focus the image.5. Turning Off The Projector First press the "off" button on the remote control orthe projector cabinet. The power light will glow amber. Then turn off the mainpower switch on the front panel. The power light will go out.IMPORTANT:• The LCD projector should be unplugged if it will not to be used for an extendedperiod.• To turn off the image briefly (five minutes or less), use the "Picture Mute" buttoninstead of turning the projector off and on.• The LCD projector will display a black or blue image if no input signal is present.• Do not turn the LCD projector off and then immediately back on. The projectorneeds to cool for a minute before it can be restarted.OPERATION5758