English-13English1. Determine the installation locationCAUTION: Installing your LCD monitor must be done by aqualified technician. Contact your dealer formore information.CAUTION: MOVING OR INSTALLING THE LCD MONITORMUST BE DONE BY FOUR OR MORE PEOPLE.Failure to follow this caution may result in injury ifthe LCD monitor falls.CAUTION: Do not mount or operate the display upsidedown, face up, or face down.CAUTION: This LCD has a temperature sensor and coolingfan. If the LCD becomes too hot, the cooling fanwill turn on automatically. If the LCD becomesoverheated while the cooling fan is running, a“Caution” warning will appear. If the “Caution”warning appears, discontinue use and allow theunit to cool. Using the cooling fan will reduce thelikelihood of early circuit failure and may helpreduce image degradation and “ImagePersistance”.If the LCD is used in an enclosed area or if theLCD panel is covered with a protective screen,please check the inside temperature of themonitor by using the “HEAT STATUS” control inthe OSD (see page 25). If the temperature ishigher than the normal operating temperature,please turn the cooling fan to ON within the FANCONTROL menu within the OSD (see page 25).IMPORTANT: Lay the protective sheet, which was wrappedaround the LCD monitor when it waspackaged, beneath the LCD monitor so asnot to scratch the panel.2. Install the remote control batteriesThe remote control is powered by two 1.5V AA batteries.To install or replace batteries:NEC recommends the following battery use:• Place “AA” size batteries matching the (+) and (-) signson each battery to the (+) and (-) signs of the batterycompartment.• Do not mix battery brands.• Do not combine new and old batteries. This can shortenbattery life or cause liquid leakage of batteries.• Remove dead batteries immediately to prevent batteryacid from leaking into the battery compartment.• Do not touch exposed battery acid, it may injure skin.NOTE: If you do not intend to use the Remote Control for along period of time, remove the batteries.3. Connect external equipment(See pages 15 and 16)• To protect the external equipment; turn off the mainpower before making connections.• Refer to your equipment user manual for furtherinformation.NOTE: Do not connect/disconnect cables when turning onthe monitor or other external equipment as this mayresult in a loss of the monitor image.4. Connect the supplied power cord• The equipment should be installed close to an easilyaccessible power outlet.• Please fasten power cord to the LCD monitor byattaching the screw and clamp.• Fully insert the prongs into the power outlet socket.A loose connection may cause image degradation.NOTE: Please refer to the “Safety Precautions andMaintenance” section of this manual for properselection of AC power cord.SetupA. Press and slide to open the cover.B. Align the batteries according to the (+) and (–)indications inside the case.C. Replace the cover.CAUTION: Incorrect usage of batteries can result in leaksor bursting.Screw Clamp