NEC MultiSync PA322UHD-2 User Manual

English-6Quick StartTo connect the LCD monitor to your system, follow these instructions:NOTE: Make sure to read “Recommended Use” (page 3) before installation.In order to display the maximum resolution, a display card that can output a resolution of 3840 x 2160 is needed.The monitor must be installed or carried by two or more people.1. Turn off the power to your computer.2. For a PC or MAC with DVI digital output: Connect the Dual Link DVI signal cable to the connector of the display card inyour system (Figure A.1). Tighten all screws.For a PC with DisplayPort output: Connect the DisplayPort cable to the connector of the display card in your system(Figure A.2).For a PC with HDMI output: Connect the HDMI cable to the connector of the display card in your system (Figure A.3).Figure A.1 Figure A.2 Figure A.3DisplayPort cable HDMI cable (not included)HDMI cable (not included)DVI cable (not included)DVI cable (not included)NOTE: 1. Please use a DisplayPort cable with a DisplayPort logo.2. When removing the DisplayPort cable, hold down the top button to release the lock.3. Height adjustment is locked by lock button. Place hand on top of the monitor to push down the screen to the lowest position.Slide the lock button to unlock the stand to raise the monitor head (Figure B.1).NOTE: Handle with care when unlocking stand.Place hands on each side of the monitor to tilt the LCD panel 30-degree angle and lift up to the highest position.Slide the cable cover up (Figure B.2).NOTE: Cable cover is not removable.Figure B.1 Figure B.230° TiltCable cover