(32/43)DelimiterCR (0Dh): End of packet12.2 Model Name ReadThis command is used in order to read the Model Name.1) The controller requests the monitor to read Model Name.Header Message Check code DelimiterSOH-'0'-Monitor ID-'0'-'A'-'0'-'6' STX-'C'-'2'-'1'-'7'-ETX BCC CRHeaderSOH (01h): Start Of Header'0' (30h): ReservedMonitor ID: Specify the Monitor ID which you want to get Model Name.Ex.) If Monitor ID is '1', specify 'A'.'0' (30h): Message sender is the controller.'A' (41h): Message type is "Command".'0'-'6'(30h, 36h): Message lengthMessageSTX (02h): Start of Message'C'-'2'-'1'-'7' (43h, 32h, 31h, 37h): Model Name commandETX (03h): End of MessageCheck codeBCC: Block Check CodeRefer to the section 4.5 “Check code” for a BCC calculation.DelimiterCR (0Dh): End of packet2) The monitor replies the model name data to the controller.Header Message Check code DelimiterSOH-'0'-'0'-Monitor ID-'B'-N-N STX-'C'-'3'-'1'-'7'-Data(0) -Data(1)—----Data(n)-ETXBCC CRHeaderSOH (01h): Start Of Header'0' (30h): Reserved'0' (30h): Message receiver is the controller.Monitor ID: Indicate a replying Monitor ID.Ex.) When this byte is set to 'A', the replying Monitor ID is '1'.'B' (42h): Message type is "Command reply".N-N: Message lengthNote.) The maximum data length that can be returned from the monitor at a time is32bytes.Ex.) The byte data 20h is encoded as ASCII characters '2' and '0' (32h and 30h).MessageSTX (02h): Start of Message'C'-'3'-'1'-'7' (43h, 33h, 31h, 37h): Model Name reply CommandData(0) -Data(1)----Data(n):Model name These data are encoded to ASCII characters strings.ETX (03h): End of MessageCheck codeBCC: Block Check CodeRefer to the section 4.5 “Check code” for a BCC calculation.DelimiterCR (0Dh): End of packet13. Security Lock13.1 Security Lock ControlThis command sets the condition of security lock function to "LOCK" or "UNLOCK".If security pass codes 1st to 4th are matched with monitor resisted pass codes, then this command