1-12 Notes on Using Your ServerFOR PROPER OPERATIONObserve the following notes for successful operation of the server. Use of the server ignoring thenotes will cause malfunctions or failures of the server. Make sure to power off the server before connecting or disconnecting cables between theserver and peripheral devices. Verify that the access LED on the server is unlit before turning off the server or ejectingthe disc. When you have just turned off the server, wait at least 30 seconds before turning it backon. If the server is connected to the UPS, set at least 30 seconds delay in the power-onschedule. Turn off the power and unplug the power cord from the outlet before relocating the server. Clean the server on a regular basis. (See Chapter 7 for cleaning.) Regular cleaningproactively prevents various failures of the server. Lightning may cause a momentary voltage drop. To prevent this problem, it isrecommended to use of an uninterruptible power supply unit. For the disc which does not conform to the standard, the playback of such a disc with theoptical disk drive is not guaranteed. If an additional LAN device is installed in PCI slot, it is hard to push the catch of theconnector with your finger that is connected to the LAN port. Disconnect the connectorpushing the catch with a standard screwdriver. At this time, be very careful for thescrewdriver not to damage the LAN port or other ports. Check and adjust the system clock before the operation if any of the following conditionsis applicable.– After carriage of device– After storage of device– After the device is entered into the pause state under the environmental conditionenduring device operation (temperature: 10°C - 35°C, humidity: 20% - 80%) Check the system clock at the rough rate of once per month. When the system clock isinstalled in a system requiring high time precision, it is recommended to use a time server(NTP server).If the system clock is remarkably delayed or advanced as the passage of time in spite ofadjustment, contact your service representative to ask maintenance. Store the unit under the storage condition (temperature: –10°C - 55°C, humidity: 20% -80%, without condensation) to allow internal devices and the unit to operate correctly inthe next operation. It is recommended that the server, the internal devices, and media (such as tape cartridge)should be stored in a place where the room temperature can be maintained. It is importantfor the server or internal devices to work normally after storage. Store the device in theplace where temperature ranges between -10 to 55°C and humidity ranges between 20 to80%, without dew condensation.
