3. EXPRESSSCOPE ENGINE 3Express5800/R120d-2M User’s Guide132Chapter 3 Setup3. EXPRESSSCOPE ENGINE 33.1 OverviewEXPRESSSCOPE Engine 3 provides a variety of features using BMC (Baseboard Management Controller),which is a system management LSI.EXPRESSSCOPE Engine 3 monitors the power unit, fans, temperature, and voltage of the server. If you havethe management LAN port connected to the network, you can remotely perform the following over a webbrowser or SSH client:• Manage the server• Remotely control the keyboard, video, and mouse (KVM)*• Remotely access a CD/DVD/floppy disk/ISO image/USB memory*.* To enable this feature, the optional license for remote management (N8115-04) is required.To actualize these functions, virtual USB mass storage (Remote FD, Remote CD/DVD, Remote USB Memory,or Virtual Flash) is always connected as USB mass storage.3.2 EXPRESSSCOPE ENGINE 3 Network configurationTo enable EXPRESSSCOPE Engine 3 to be used via network, network configuration is required. Below is anexample of the configuration procedure which enables EXPRESSSCOPE Engine 3 to be used via a webbrowser.1. Run POST following Chapter 3 (1.1.1 POST sequence). Wait until the following message appears onthe lower left of the screen.Press SETUP, Internal Flash Memory, ROM Utility, Network2. If you press the key at this time, Off-line TOOL starts upon completion of POST. You can alsopress the key while the NEC logo is being displayed to open the Off-line TOOL MENU screen.3. The keyboard selection screen appears. Select your keyboard type.After that, the Off-line TOOL MENU screen appears. On this screen, specify the network settings forEXPRESSSCOPE Engine 3.4. When the Off-line TOOL MENU appears, select BMC Configuration, BMC Configuration, Network,and then Property.
